|
|
|
Výrobce: |
Sony |
|
Kód zboží: |
Sony TA-FA30ES |
Cena: |
13 400,00 Kč |
|
|
|
super stav, špičkový zvuk Manuál/schéma ke stažení zde (2,9MB), jen PA System Power Amplifier: Pure-complementary SEPP MOS FET power amplifier with all stages directly coupled Preamplifier: Low-noise, high-gain equalizer amplifier Power section: Large-capacity power supply advanced STD Rated output 4 ohms, 120 W + 120 W (DIN 0.7%, 1 kHz) 8 ohms, 80 W + 80 W (DIN 0.7%, 1 kHz) Speaker Impedance 4 to 16 ohms Output bandwidth (8 ohms) 10 Hz to 100 kHz (at 40 W output, and high-frequency distortion rate of 0.08%) Total harmonic distortion 0.008% (at 8 ohms, 10 W output) Damping factor 100 (8 ohms, 1 kHz) Intermodulation (1M) distortion (60 Hz : 7 kHz = 4 : 1) 0.008% (8 ohms) Throughrate 125 V/μ sec, 250 V/μ sec (Inside) Residual noise Less than 100 μV (network A) Equalizer deviation PHONO MM: 20 Hz to 20 kHz, ± 5 dB Frequency response TUNER, CD, AUX, TAPE1/DAT, TAPE2/MD: 7 Hz to 100 kHz +0, -3 dB S/N PHONO MC: 78 dB (network A, 0.5 mV) MM: 95 dB (network A, 5 mV) TUNER, CD, AUX, TAPE1/DAT, TAPE2/MD: 105 dB Inputs Input sensitivity and impedance PHONO MC: 0.17 mV, 100 ohms MM: 2.5 mV, 50 kilohms TUNER, CD, AUX, TAPE1/DAT, TAPE2/MD: 150 mV, 20 kilohms Maximum input capability (1 kHz) PHONO MC: 9 mV MM: 150 mV Outputs Output level/impedance REC OUT 1, 2: 150 mV, 1 kilohm PHONES: 10 mW (at 8 ohms) Tone controls BASS (100 Hz): ± 7 dB TREBLE (10 kHz): ± 7 dB General Power requirements 230 V AC, 50/60 Hz Power consumption 220 W Dimensions (approx) (w/h/d) 430 ´ 150 ´ 415 mm incl. projecting parts and controls Mass (approx) 11.0 kg Supplied accessories Remote commander (remote ) RM-S326 (1) Sony batteries R6 (size-AA) (2) Main features - Power output 2 x 120 W (DIN 4Ω)
- Fixed optical bias circuit
- Pure input circuit
- Radial heat sink, aluminium heat sink
- ES filter
- Gold plated line terminals
- MOSFET power stage
- Twin mono construction
- TORUS transformer
- Speaker A/B
- Bi-wiring
- 6 audio inputs
- EON Link system to Sony RDS/EON tuner
- Tone and balance control
- Loudness function
- Source direct
- Tape monitor
- Low stand-by power consumption
- System remote commander
Technical spec - MOS-FET Power Amplifier
- MOS-FET Drive and Power Stage
- Toroidal Transformer
- STD Power Supply
- SLL Technology
- G-chassis/G roof: FB
- 6 Audio inputs § Phono Input: MM/MC
- Relay input select switch
- 2 x Tape monitor
- Source Direct
- Muting Function
- Speaker Outputs (A/B): Bi-Wiring (banana)
- Off centre Insulator
- Infared System Remote commander RM-S326
- Power Output (DIN): Stereo
- 4 Ohm 2 x 120W
- 8 Ohm 2 x 80W
- (RMS): 20-20.000 Hz: 4 Ohm 2 x 90 W
- (RMS): 20-20.000 Hz: 8 Ohm 2 x 70 W
- Distortion: <0.008%
- Frequency Response (CD in): 7-100.000 Hz; +0/-3 dB
- Signal to Noise Ratio: 105 dB
- Damping Factor: 100
- Inputs
- Phono MM: 1 2.5 mV/50kOhm
- 1 Phono MC
- 1 Tuner: 200mV/30kOhm
- 1 CD: 150mV/20kOhm
- 1 Aux: 150mV/20kOhm
- 1 Tape: 150mV/20kOhm
- 2 MD: 150mV/20kOhm
- Outputs
- Rec Out Tape: 150mV/1kOhm
- 2 Rec Out MD: 150mV/1kOhm
- 1 Headphone: 10mW/8Ohm
- General Specifications
- Power Requirement: 230V; 50/60Hz
- Power Consumption: 220W
- Dimensions: 430 x 150 x 415 mm
- Weight: 11Kg
|
|